Removing A Tool From Multitool - Siemens SINUMERIK 840D sl Universal Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl Universal:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
12.15.4
Removing a tool from multitool
If the multitool was mechanically re-equipped, then the old tools in the tool list must be removed
from the multitool.
To do this, the cursor is positioned at the line where the tool which is to be removed is located.
When unloading, the tool is automatically saved in the tool list outside the magazine in the NC
memory.
Procedure
Universal
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
2.
Position the cursor on the tool that you want to load into the mul‐
titool.
3.
Press the "Load" and "Multitool" softkeys.
The "Load on ..." window opens.
4.
Select the required multitool and the multitool location to which
you wish to load the tool.
1.
The tool list is opened.
2.
Position the cursor on the tool that you would like to unload from
the multitool and press the "Unload" softkey.
- OR -
Position the cursor on the tool that you want to remove and delete
from the multitool and press the "Delete tool" softkey.
Tool management
12.15 Working with multitool
313
Advertisement
Table of Contents
