Fax Extension; Digital Pager Callback Number; Delay In Dialing Digital Pager Callback Number - NEC IntraMail 4 System Manual

8000 - Voice Mail
8004 - IntraMail System Options
when a user dials G while listening to a message.
See the following for more:
See Listening to Messages on page 109.
■
Message Length on page 131.
■
Options
1-60 Seconds.
■
Default
✔ 5 Seconds.

Fax Extension

(FAX TRANSFER EXT)
Use this option to specify which system extension is the fax machine. When the Automated Attendant
answers a call and detects fax (CNG) tone, it automatically transfers the call to this extension.
See Fax Detection on page 86 for more.
■
Options
UND (Undefined, entered by pressing CLEAR )
■
Extension number (e.g., 320).
■
Default
✔ UND (Undefined, entered by pressing CLEAR )

Digital Pager Callback Number

(PAGER CALLBACK NUM)
Use this option to set the Digital Pager Callback Number portion of the Message Notification callout num-
ber for a digital pager. This is the portion of the callout number that is appended to the pager service tele-
phone number. Normally, this option should be X*M#, where:
- X is the number of the extension that generated the notification.
- * is a visual delimiter (to make the pager display easier to read).
- M is the number of new messages in the extension's mailbox.
- # is the digit normally used by the pager service for positive disconnect.
See Message Notification on page 133 for more.
■
Options
Digits (12 maximum, using 0-9, # and *)
■
M (Number of messages) (Entered by pressing MW )
■
N (None) (Entered by pressing CLEAR )
■
X (Extension number) (Entered by pressing ICM )
■
IntraMail automatically replaces the X command with the number of the extension that initially
received the message.
Default
✔ X*M#

Delay in Dialing Digital Pager Callback Number

(PAGER DIAL DELAY)
Use this option to set the delay that occurs just before IntraMail dials the Digital Pager Callback Number
portion of the Message Notification callout number for a digital pager. Set this delay so the pager service has
enough time to connect to the digital pager before sending the callback number. Your pager service may be
able to help you determine the best value for this option (0-99 seconds). By default, this option is 9 seconds.
When placing a digital pager notification, the system:
Seizes the trunk specified.
1.
2. Dials the user-entered notification number (in MSG + OP + N ).
3. Waits the 8004 - Delay in Dialing the Digital Pager Callback Number interval.
4. Dials the number entered in 8004 - Digital Pager Callback Number.
The system assumes that the notification number will complete dialing approximately 4 seconds after trunk
214 ◆ Chapter 3: Programming
IntraMail System Guide