Connecting To A Cable Box Or Satellite Receiver - Pioneer XV-DVR9H Operating Instructions Manual

Other connections

Connecting to a cable box or satellite receiver

If you have a cable box or satellite receiver with a built-in decoder, connect it to this system and your TV as shown on
this page. If you are using a separate decoder box for your cable/satellite TV, set up following the instructions on the
next page.
Using the setup on this page you can:
• Record any channel by selecting it on the cable box/satellite receiver.
Important
• Do not connect this system 'through' your VCR, satellite receiver or cable box to your TV.
ANTENNA
IN
SCART AV
CONNECTOR
1 2
TV
IN OUT
VHF/UHF ANTENNA
L
OUT IN
AV 2 (LINE1/ DECODER)
R
ANALOG AUDIO
IN
FM UNBAL AM
75Ω LOOP
AM/FM ANTENNA
CONTROL USE ONLY WITH S-DVR727H SW
1
ANTENNA
OUT
ANTENNA
IN
1
Antenna/cable TV
wall outlet
SCART AV
CONNECTOR
AV 1 (RGB) - TV
AC IN
OUT IN
OPTICAL DIGITAL AUDIO
4 4
3
OPTICAL
OUT
SCART AV
CONNECTOR
SCART AV
Cable box/
CONNECTOR
Satellite receiver
1 Connect RF antenna cables as shown.
This enables you to watch and record TV channels.
2 Use a SCART cable to connect the AV1(RGB)-TV
AV connector to a SCART AV connector on your TV.
This enables you to watch discs.
3 Use another SCART cable to connect the
AV2(LINE 1/DECODER) AV connector to a SCART AV
connector on your satellite receiver/cable box.
This enables you to record scrambled TV channels.
4 Use an optical digital audio cable to connect the
OPTICAL DIGITAL AUDIO IN jack to an optical digital
audio output on your satellite receiver/cable box.
Use a SCART cable to connect your satellite receiver/
cable box directly to your TV.
This enables you to listen to digital broadcasts, watch
satellite/cable channels directly on your TV (while
recording something else).
Tip
• This system has a 'through' function which allows
you to record a TV program from the built-in TV tuner
in this system while watching a video playing on your
VCR (see also Tip on page 47).
• To use this feature when the system is in standby,
Power Save must be set to Off—see Power Save on
page 102.
16
117
En