Black & Decker BAPUV350 Instruction Manual page 11

CLEANING AND MAINTENANCE
FILTER INSTALLATION
Your air purifier comes with a 4 stage (Pre-filter, Electrostatic Precipitator Filter,
Ozone Removal Filter, HEPA/Activated Carbon Filter) Filtration system.
To access the filters:
1. Remove the back panel by pulling the top outwards with both hands.
2. The filters are numbered. Slide out the filter that needs to be cleaned or
replaced.
3. Make sure washable filters are completely dry before re-installing back into unit.
4. Slide the filter back in to the appropriate slot.
The FILTER REPLACEMENT
The HEPA/Activated Carbon filter will need to be replaced.
You may need to replace it sooner if you are using the air purifier in an environment
with poor air quality. If you notice that the filter does not appear visibly clean, or air
purification seems to have decreased, the filters should be replaced.
NOTE: After replacing the filters, touch and hold the
The REPLACE FILTER indicator light will turn off and the other control panel
lights will illuminate.
WARNING: Do not run the unit without the filters in place.
STORAGE
If you are not going to use the air purifier for a long time, make sure it is clean and
dry. Wrap the filter in plastic. Store in a cool dry place.
indicator light will illuminate after 2,160 hours of use.
light for 5 seconds to reset.
Page 11