Advertisement
Control Panel
START/STOP
Water droplet light flashes 3 times then
illuminates white when ready or when
dispensing water. The light extinguishes when
in standby mode.
5°C, 10°C & 15°C
Light illuminates against the selected cold
temperature.
CHILLING
Illuminates blue when compressor is on.
Flashes on and off to indicate that the
compressor is turning on and off to maintain
the set temperature (ambient, 5°C, 10°C &15°C).
READY
Light illuminates white when set temperature
has been reached
AMBIENT
Light illuminates white when selected.
FILTER RESET
Light illuminates as a reminder to change the
filter cartridge once the filter life timer has
counted down.
PROGRAM TABLE
Function
Water Dispensing
Flow Rate
Cold
1L/min
Ambient
1L/min
^Temperature is measured in the chilling chamber not from the spout.
#Dispensed Ambient water temperature will vary.
8
FILL TANK
The water droplet light on the START/STOP
button will illuminate solid red to alert the user
that the water tank needs to be filled. The unit
will not dispense water until the tank is refilled.
Once the tank has been filled, The water
droplet light on the START/STOP button will
no longer illuminate.
NOTE
Take care when removing the water tank from
the base after use as residual water may drip.
NOTE
• The unit will not dispense any water while the
tank is below the minimum water level.
• Ensure the water level is always above the
MIN level for optimum flow rate.
^Preset Temp °C
^Temp Range °C
5
5 to 15
Temp of Water
N/A
inside Water Tank#
15ºC
10ºC
AMBIENT
FILTER
5ºC
RESET
START | STOP
READY
Temp +/-
Preset Volume
Increments
MLS
5
Stops dispensing
after 1 minute.
N/A
Stops dispensing
after 1 minute.
Advertisement
