Table of Contents
Advertisement
3.3 Installing the 4-port KVM Switch
If you don't have a 4-port KVM Switch, please skip this section and go to the section for
[Connecting and Removing the Cables].
Refer to [Connecting to Ports] for the connection in general. In details, refer to the original
manual for the 4-port KVM switch.
CAUTION
1.
Take out four screws packed in nylon bag, which is taped on the open space area of the
rear top pa
nel. Make sure the rubber feet on the bottom of the 4-port KVM switch are
removed .
2.
Insert the 4-port KVM switch into the open space area of the rear top panel, making
sure that
the 4-port KVM switch's connectors face out from the rear of the Console
Drawer.
3.
Fasten the 4-port KVM
rear top panel metal.
To avoid electric shocks and/or short circuits, make sure that the
power cable of this device is not plugged into the power outlets.
Since this device may cause injury if it falls or tips over, be sure to
work on a stable surface, such as on desk, table a
This device contains components that store and release high
voltage electric charges. Make sure to work only after checking that
it has been electric
Be careful not to cut yourself by sharp metal edg
To avoid damage, be careful of any objects falling (including m
objects, water, and liquids) into this device. Do not touch
un
necessary place.
To install 4 port KVM switch, refer to the manual of 4port KVM
switch.
Prepare screwdrivers (large and small) in advance.
It is strongly recommended
the Console Drawer from the rack.
When removing Console Drawer, se
Drawer]. It requires the procedure in reverse order.
switch in place with the four screws, taken in step 1, over the
ally discharged.
to install the 4-port KVM after removal of
e
nd so on.
es.
[Installing the Console
etal
9
Advertisement
Table of Contents
