Table of Contents
Advertisement
11. TD ASSY Replacement Procedure
Please replace the TD ASSY if malfunction occurs. The TD ASSY must be fixed in the correct position.
If there was a flaw in the process, there is a possibility that the TA mode will not work correctly, in this case
please follow the instructions below.
Notice:
Turn off the power during the procedure.
Since the magnetic force of the TD ASSY is strong, avoid close contact with your magnetic storage devices and
mechanical watches.
Required tools:
Allen wrench (3mm)
Phillips screwdriver #2
Structure:
Soundboard
Anchor
Procedures:
1) Removing the TD ASSY
1-1. Remove the white square connector.
1-2. Please cut the Cable tie of the TD ASSY's wire bundle.
TD shaft Assy
When disconnecting, press the upper side then pull
apart like the figure below.
- 10 -
TD ASSY
Bobbin
Advertisement
Table of Contents
