Operation - Buffalo DW467 Instruction Manual

Detergent Pump
Detergent amount required is dependent on soil and water hardness. Dosage can be
regulated by a screw above and on the right of the glass cover. The regulation can be from 0
lt/hour to 3.0 lt/hour. Adjust the quantity by regulating the dosing. Turning the adjustment
screw clockwise, the flow is reduced (-), turning it counterclockwise the flow is increased (+).
The detergent pump is factory set at the maximum (3.0 lt/hr).
Rinse Aid Pump
Rinse Aid amount required is dependent on water hardness. Dosage can be regulated by a
screw above and on the right of the glass cover. The regulation can be from 0 lt/hour to 0.7
lt/hour. The rinse aid pump suctions 0.7 ml per rotation of the rotary mechanism. Adjust the
quantity by regulating the dosing. Turning the adjustment screw clockwise, the flow is
reduced (-), turning it counterclockwise the flow is increased (+).The rinse-aid pump is
factory set at the maximum (0.7 lt/hr).

Operation

Control Panel - DW464
Control Panel - DW467 / DW468
Starting the Washing Procedure
1. Check that there are sufficient detergents in the chemical containers and that the drain
and overflow pipe has been replaced in the correct position if it was removed for
cleaning.
2. Close the door and turn on the glasswasher by using the on/off button.
3. The Glass Washer will fill automatically and both the tank and booster will begin to heat.
DW464 - The warming indicator light will illuminate showing that the water is being
heated.
DW467/DW468 - The tank and boiler indicator lights will illuminate showing that the
water is being heated.
4. DW464 - When the warming indicator light turns off the machine is ready.
Note - The full heating process is finished when warming light is off.
Loading the Basket
Load glasses into the basket ensuring all dregs are removed.
Do not stack glasses.