Operation - Buffalo DW319 Instruction Manual

Operation

Control Panel – DW319
Starting the Washing Procedure
1. Check that there are sufficient detergents in the chemical containers and that the drain
and overflow pipe has been replaced in the correct position if it was removed for
cleaning.
2. Close the door and turn on the Dishwasher by using the on/off button.
3. The Dishwasher will fill automatically and both the tank and booster will begin to heat.
The tank and boiler indicator lights will illuminate showing that the water is being heated.
Note - The full heating process is finished when warming light is off.
Loading the Basket
Load dishes into the basket ensuring all debris is removed.
Open the door and place basket in the machine.
Note – Empty debris dishes into sink/receptacle. DO NOT EMPTY IN THE MACHINE.
Starting a Wash Cycle
1. Close the door. Ensure the door is closed properly. The Dishwasher will not start if the
door is not closed
2. Press the start button to initiate the washing cycle. The program light indicator will
illuminate while washing cycle is in progress
3. When the full washing cycle finishes, the program light indicator turns off and you can
remove the basket
Note - Pay attention when removing the basket after the washing cycle as it may be hot!
Note - Let the dishes dry out of the glasswasher
.