Technical Information - Zanussi ZFU23400WA User Manual

4. Remove the door.
5. Unscrew the upper pin and screw it on the
opposite side.
2
1
6. Refit the door.
Make sure the edge of the door is parallel
with the edge of the top.
7. Unscrew the pin (A) and screw it on the
opposite side.
A
B
8. Remove the cap (B) and position it on the
opposite side.
9. Screw the lower hinges.

Technical information

Technical data
Height
Width
Depth
Rising time
Voltage
Frequency
www.zanussi.com
10. Refit the plinth.
11. Stand the appliance upright.
12. Fit the handle on the opposite side and put
the plastic caps (contained in the
instructions bag) in the free holes.
CAUTION!
Reposition, level the appliance, wait
for at least four hours and then
connect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes
correctly.
If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case,
wait for the natural fitting of the
gasket.
In case you do not want to carry out
the above mentioned operations,
contact the nearest Authorised
Service Centre. The Authorised
Service specialist will carry out the
reversibility of the doors at your cost.
mm
mm
mm
Hours
Volts
Hz
1540
595
668
20
230 - 240
50
27