Table of Contents
Advertisement
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
Replacing the lamp
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).
Technical information
Technical data
Dimensions of the recess
Height
Width
Depth
Rising time
Voltage
Frequency
The technical information are situated in the
rating plate, on the external or internal side of
the appliance and in the energy label.
Installation
WARNING!
Refer to Safety chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
10
3. Replace the used lamp with a new lamp of
the same power and specifically designed
for household appliances (the maximum
power is shown on the lamp cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
mm
mm
mm
Hours
Volts
Hz
Climate
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
1446
560
550
20
230 - 240
50
Ambient temperature
www.zanussi.com
Advertisement
Table of Contents
