Clamping The Outboard Motor - Yamaha F15C Owner's Manual

Installation
ufacturer for further information on deter-
mining the proper mounting height.
For instructions on setting the trim angle of
●
the outboard motor, see page 52.
EMU26971

Clamping the outboard motor

1. Place the outboard motor on the tran-
som so that it is positioned as close to
the center as possible. Tighten the tran-
som clamp screws evenly and securely.
Occasionally check the clamp screws
for tightness during operation of the out-
board motor because they could be-
come loose due to engine vibration.
WARNING! Loose
could allow the outboard motor to fall
off or move on the transom. This
could cause loss of control and seri-
ous injury. Make sure the transom
screws are tightened securely. Occa-
sionally check the screws for tight-
ness during operation.
2. If the engine restraint cable attachment
is equipped on your engine, an engine
restraint cable or chain should be used.
Attach one end to the engine restraint
cable attachment and the other to a se-
cure mounting point on the boat. Other-
wise the engine could be completely lost
if it accidentally falls off the transom.
38
clamp screws
[EWM00641]
ZMU02012
3. Secure the clamp bracket to the transom
using the bolts provided with the out-
board (if packed). For details, consult
your Yamaha dealer. WARNING! Avoid
using bolts, nuts or washers other
than those contained in the engine
packaging. If used, they must be of at
least the same quality of material and
strength and must be tightened se-
curely. After tightening, test run the
engine and check their tightness.
[EWM00651]
1
1. Bolts
ZMU02013
ZMU02637