Catalyst Os Software; Initial Configuration - Cisco Network Analysis Module 6000 Installation And Configuration Manual

Configuring the NAM

Catalyst OS Software

These sections describe how to configure the NAM from the CLI:
•
•
•
•
•

Initial Configuration

Before you can use the NAM for network analysis, you must log into the NAM root account and
configure the following:
•
•
•
•
•
•
•
•
•
To configure these parameters for the NAM, perform these steps in privileged mode:
Verify that the NAM is installed and that the power is on by entering this command:
Step 1
Console> show module mod
Establish a console session with the NAM by entering this command:
Step 2
Console> (enable) session mod
At the login prompt, type root to log into the root account.
Step 3
At the password prompt, type root as the root password.
Step 4
Note
Catalyst 6000 Family Network Analysis Module Installation and Configuration Note
24
Initial Configuration, page 24
Configuring VLANs, page 27
Using NetFlow Data Export as a Traffic Source, page 27
Using SPAN as a Traffic Source, page 28
Configuring the SNMP Agent, page 29
IP address
Subnet mask
IP broadcast address
IP host name
Default gateway
Domain name
If applicable, the DNS name server.
If using an external SNMP manager to communicate with the NAM you must configure the
following:
SNMP MIB variables
–
Access control for the SNMP agent
–
System group settings on the NAM
–
Start the web server using the ip http server enable command.
If you have not changed the password from the factory-set default, a warning message
displays. To change the password from the default, see the
NAM CLI Passwords" section on page 48
"Changing and Recovering the
for more information.
78-10406-05