Rear Panel 1 - Kenwood CS-6040 Instruction Manual

REAR PANEL
(49) Z A X I S INPUT Jack
Input of the external intensity modulation. Positive vol-
tage reduces intensity, and TTL-level voltage activates
intensity modulation.
(§) Fuse Holder and Line Voltage Selector
1.2 A fuse is built in for 1 0 0 / 1 2 0 V areas. 0.8 A fuse
is built in for 2 0 0 / 2 4 0 V areas.
Before changing the line voltage setting, unplug the A C
cable. For line voltage selection, refer to the main-
tenance instructions in this manual.
© CH1 OUTPUT Jack
Outputs channel-1 vertical signal by A C coupling. Used
to measure frequency, etc. by connecting a counter to
it. Frequency measurement using a counter may be in-
fluenced by noises, resulting in improper frequency dis-
play. In s u c h a c a s e , change the V O L T S / D I V setting to
another range or C H 1 V A R I A B L E control @ to a posi-
tion other than C A L . Cascade connection of the chan-
nel 1 and channel 2 is impossible.
18
Fig. 6
(§) A C Connector
Connector for A C power supply.
© Cable Hooks
Used to roll up the A C cable for transportation or
storage. Also serve as the base for vertical installation.
@ PROG STEP INPUT Jack
The input terminal for advancing the counter one step
in the Program Execution mode.