Table of Contents
Advertisement
C O N T R O L S AND INDICATORS
REAR PANEL
©
Z AXIS INPUT
External intensity modulation input; TTL compatible.
Positive voltage increases brightness, negative voltage
decreases brightness.
®
CH1 PEN OUT
Storage waveform output terminal for channel-1 pen
recorder. Setting t h e DISPALY select switch @ on
the front panel to the START position starts output.
When t h e MODE select switch ( Q ) is set to the ADD
position, synthetic storage waveform of channels 1
and 2 is output.
NOTE: When the MODE select switch ®
CH2 position, channel-1 waveform is not out-
put.
@
CH2 PEN OUT
Storage waveform output terminal for channel-2 pen
recorder. Setting t h e DISPLAY select switch ©
the front panel to t h e START position starts output.
NOTE: When the MODE select switch ( Q ) is set to the
CH1 or ADD position, channel-2 waveform is
not output.
Fig. 5
@> Fuse Holder, Line Voltage Selector
Contains the line fuse. Verify that the proper fuse is in-
stalled when replacing the line fuse.
100 V, 120 V
220 V, 240 V
After pulling the power cord plug from the power
outlet, adjust this selector to your line voltage.
(fj )
Power Input Connector
Input terminals of power supply. Connect the AC cord
provided.
is set to the
on
1.2 A
0.8 A
13
Advertisement
Table of Contents
