Removing The Cylinder Head; Removing The Piston - Husqvarna FC 350 2014 Repair Manual

17 ENGINE
17 .3.12

Removing the cylinder head

17 .3.13

Removing the piston

-
Remove nut
G00485-10
-
Loosen nuts @ in a crisscross pattern and remove them with the washers.
-
Remove the cylinder head.
-
Remove cylinder head gasket
-
Push the cylinder upward.
• Info
I
Only push the cylinder as far up as necessary to take the piston pin out.
Remove the piston pin retainer
-
Remove the piston pin.
-
Take off the cylinder and piston.
-
Push the piston upward out of the cylinder.
• Info
I
If no further work is to be performed on the cylinder and piston, the piston
can remain in the cylinder.
-
Take off cylinder base gasket @ .
O
with the washer.
@).
0-
135