Makita PO5000CX2 Instruction Manual page 6

NOTICE:
Always turn the knob fully. If the knob
is in the middle position, you can not turn on the
tool.
NOTICE:
You can not change the action mode
when the tool is switched on.
Random orbit with forced rotation
mode
Random orbit with forced rotation mode is orbital action
with forced rotation of the pad for rough polishing such
as surface treatment.
Rotate the change knob counterclockwise for random
orbit with forced rotation mode.
Random orbit mode
Random orbit mode is orbital action with free rotation of
the pad for fine polishing.
Rotate the change knob clockwise for random orbit
mode.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Installing the backing pad
1
► 1. Backing pad 2. Hex wrench
Put the backing pad on the shaft then turn the bolt
clockwise with a hex wrench.
CAUTION:
Make sure that the backing pad is
secured properly. Loose attachment will run out of
balance and cause a excessive vibration which may
cause loss of control.
Installing side grip
Optional accessory
► 1. Cap 2. Side grip
Remove the cap and screw the side grip on the tool
securely.
The side grip can be installed on either side of the tool.
6
2
1
2