Installing The Router In A Rack - Cisco CISCO2691 Installation Manual

Installing the Router in a Rack

Figure 5
Left bracket
for 23-inch rack
Figure 6
Right bracket
for 23-inch rack
Installing the Router in a Rack
Install the chassis in the rack using the appropriate rack-mounting screws. Use two screws on each side.
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
Warning
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
•
•
•
To see translations of the warnings that appear in this publication, refer to the Regulatory Compliance
Note
and Safety Information document that accompanied this device.
Mounting Bracket Installation on Cisco 2691, Cisco 3631, and Cisco 3725 Routers
6
Bracket Installation—Center Mounting with Front Panel Forward
Left (narrow) bracket
for 19-inch rack
Bracket Installation—Center Mounting with Rear Panel Forward
NM -HD
V
BA NK 4
BA NK 3
BA NK 2
BA NK 1
Right (wide) bracket
for 19-inch rack
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing
the unit in the rack.
Use two screws on each side.
BA NK 0
V0 SEE MANU
AL BEFO DSU
RE INSTA
EN LLATI ON 56K
SEE MANU
AL BEFO DSU
RE INSTA
LLATI ON 56K
SEE MANU
AL BEFO
Use two screws on each side.
Right (wide) bracket
for 19-inch rack
RE INSTA
LLATI ON
Left (narrow) bracket
for 19-inch rack
Right bracket
for 23-inch rack
Left bracket
for 23-inch rack
78-15162-01