Table of Contents
Advertisement
To stop the timer recording in progress
Press [STOP C] to stop the disc recording or [STOP C/EJECT A] to
stop the tape recording on the front panel of the unit.
If the timer programming did not complete correctly
The error number appears on the
Timer Programming list.
Timer Programming
Date
Start
End
01/01 12:00
13:00 P01
*
2. - - -
3. - - -
The error programme will be
displayed in grey with an asterisk
and have an error number.
The error programme will be
deleted once you check the error
in the programme list, or once
you cancel the timer-standby
mode and re-enter it.
Press [CLEAR/C-RESET] to erase
the selected programme.
VPS (Video Programme System) / PDC (Programme Delivery Control)
The Video Programme System (VPS) or Programme Delivery Control (PDC) assures that the TV programmes
you have programmed for timer recording are recorded exactly from beginning to end, even if the actual
broadcasting time differs from the scheduled time due to a delayed start or extension of the programme
duration. Furthermore, if a programme is interrupted, the recording will also be interrupted automatically
and resumed when the programme starts again.
If the VPS / PDC signal drops out because the broadcast signal is weak, or if a broadcasting station does not
transmit a regular VPS / PDC signal, the timer recording is performed in normal mode (without VPS / PDC)
even if it was programmed for VPS / PDC. If the starting time of the VPS / PDC timer recording is between
0:00 and 3:59 on a given day, the VPS / PDC function will operate from 20:00 on the previous day to 4:00
on the next day. If the starting time of the VPS / PDC timer recording is between 4:00 and 23:59 on a given
day, the VPS / PDC function will operate from 0:00 on the given day to 4:00 on the next day. This means
that if the relevant programme is broadcasted within this period, it is recorded correctly. If the timer is not
programmed correctly, the incorrect timer setting stays in effect unless you cancel it. To cancel an incorrect
timer setting, refer to "Checking, cancelling, or correcting the timer programming information" on page 32.
Downloaded from:
http://www.usersmanualguide.com/
Timer Recording (cont'd)
The error numbers indicate:
E1-22
VCR
DVD
E37-39
DVD
VPS
CH
Mode
VCR
PDC
DVD
E1
ON
E23-24
E25
E26-28
E29
E30
E31
E32
E33
Recording
Recording error
Unrecordable disc
• Copy prohibited programme
• Cannot record because of the
NTSC / PAL-60 signal is received.
Copy prohibited programme
Disc protected
Disc full
Already recorded 99 titles (Video
mode)
Already recorded 99 titles (VR
mode)
Already recorded 999 chapters
Note
• [STOP C] on the remote
control is not effective.
E34
No space for Control information
E35
PCA (Power Calibration Area) full
E36
Already finalised Video format disc
E40
• There are some unrecorded
parts due the overlapped timer
programmes.
• Recording did not start at the
start time.
• There is no tape in the cassette
compartment.
• Tape recording reaches to
the tape end during timer
recording.
E41
Power failure
E42
No disc
EN
33
Advertisement
Table of Contents
