ABB XAC25849 Operation Manual page 53

Operation Manual / TPR56-F + TPR61-F
6 Removal and installation / 6.2 Removing the turbocharger
6.2.2 TPR56-F28/TPR61-F66 (with support)
If provided
Only TPR56-F28
Only TPR61-F66
© Copyright 2018 . All rights reserved.
Disconnect all gas, air and oil pipes in accordance with the engineb-
u
uilder's instructions.
Unscrew the cable connector (86515) on the speed sensor.
u
Inspect the lifting gear.
u
Attach one lifting gear each to the two fins of the bearing casing
u
provided for this purpose.
Unscrew and remove nut (03).
u
Undo and remove fastening (01) as per the enginebuilder's instruc-
u
tions.
Lift the turbocharger off the engine and set it down to one side.
u
WARNING
Beware of tilting
If support for the turbocharger is not provided or is inadequate, the
turbocharger could tip over during installation or removal and cause a
serious or even fatal injury.
Wear personal protective equipment (PPE).
u
Support the turbocharger at a suitable point.
u
Secure with lifting gear wherever possible.
u
Support the turbocharger at a suitable point.
u
Cover the oil connection.
u
HZTL2499_EN Revision F December 2018