Powering The Homebase Device - Honeywell Dolphin 7600 User Manual

Powering the HomeBase Device

The terminal requires 5 volts DC input for communication and battery charging; the power adapter on the
power cable converts the voltage from the power source to 5 volts DC. Only power adapter cables from
Honeywell convert the voltage appropriately.
The same power cable that ships with each terminal can be used to power the HomeBase. This cable
contains a plug adapter for each geography (US, UK, EU, etc.).
1. Attach the appropriate plug adapter to the power adapter.
2. Plug the power cable into the power source.
3. Plug the connector into the DC power jack on the back panel. The HomeBase is now powered.
When a terminal is properly seated in the terminal well, the HomeBase powers the terminal, charges the
terminal's main battery pack, and launches ActiveSync (see
Honeywell recommends that you leave the HomeBase connected to its power source at all times, so that
it is always ready to use.
10 - 4
1
ActiveSync Communication
Rev A
5/23/2008
Plug Adapter
Power Adapter
Power Cable
Dolphin® 7600 Mobile Computer
on page 3-18).
User's Guide