Cisco 2691 Installing And Formatting page 14

Internal CompactFlash Memory Card Installation and Removal
Place the removed CompactFlash memory card on an antistatic surface or in a static shielding bag.
Step 4
Installing an Internal CompactFlash Memory Card
Cisco 2691 routers, Cisco 3631 routers, and Cisco 3700 series routers have an internal connector for a
Compact Flash memory card. You can install a CompactFlash memory card with 32-, 64-, or 128-MB of
memory.
Complete the following steps to install an internal CompactFlash memory card:
Locate the CompactFlash memory-card connector on the CPU/mainboard. (See
Step 1
Figure
Insert the connector end of the CompactFlash memory card into the connector until the card is seated in
Step 2
the connector. The card is keyed so that it cannot be inserted incorrectly.
If there was a retention screw, reinstall it in the standoff.
Step 3
Install the plug-in CPU/mainboard or the chassis cover as described in the
Step 4
CPU/Mainboard" section on page 14
page
Step 5 Refer to the
instructions on formatting the CompactFlash memory card.
Reinstalling a Plug-in CPU/Mainboard
This section describes how to reinstall a plug-in CPU/mainboard. You need a number 2 Phillips
screwdriver or flat blade screwdriver to complete this procedure:
Place the chassis so the empty CPU/mainboard slot faces you.
Step 1
Make sure that the ejector levers are fully open. Carefully insert the CPU/mainboard into the chassis
Step 2
slot until the connector is engaged, then close the ejector levers to fully seat the CPU/mainboard
connector. (See
Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards
14
6, or Figure 7.)
16.
"Formatting Procedures for CompactFlash Memory Cards" section on page 20
Figure 13.)
or the "Reinstalling the Cover on a Cisco Router" section on
March 2002
Figure 4, Figure 5,
"Reinstalling a Plug-in
for
78-13892-03