Related Manuals for Black & Decker POWER TO GO
Summary of Contents for Black & Decker POWER TO GO
- Page 1 POWER TO GO ™ Quick Start Guide WARNING Read all your vehicle and the lithium-ion battery booster instructions before operating the unit. Failure to follow instructions may result in electric shock, fire and/or serious injury.
- Page 2 ICONS + COLORS SOLID The POWER TO GO™ Li-Ion Battery Booster is equipped with a single LED indicator BLINKING ring that changes color depending on unit’s function or condition. This guide indicates what the icons and ALTERNATING COLORS colors mean:...
- Page 3 UNIT BATTERY Medium Full Charging STATUS VEHICLE Ready Boost Boost Boost BOOSTING to Start Stage 1 Stage 2 Stage 3 STATUS Vehicle FAULT Vehicle Low Battery Unit Overheat, Battery Voltage CONDITIONS Reverse Clamps Fault Recharge Unit...
- Page 4 HOW TO BOOST A VEHICLE 1. Connect to the vehicle (two ways to connect): A. Connect the unit B. Connect the unit directly to the vehicle’s to the vehicle battery DC accessory outlet. with the included battery clamps.
- Page 5 2. Press the main power button to turn the unit ON. The POWER TO GO™ will automatically detect the vehicle’s depleted battery and will begin the process to boost.* 3. When the LED changes to solid green the vehicle is ready to start.
-
Page 6: Area Light
AREA LIGHT 1. Press the Main Power Button to turn the unit ON. 2. Press the USB/ Light Button to turn on the LED area light. 3. To turn the light OFF, press the USB/ Light Button again. - Page 7 4. To turn o the USB port, press and hold the USB/Light Button for 2 seconds and release. Hold for 2 Seconds and release Note: After 1 Minute of inactivity the POWER TO GO™ will shut down to protect the internal battery.
- Page 8 HOW TO CHECK THE UNIT BATTERY STATUS Press the Main Power Button. The LED Indicator ring will light up Blue, Yellow or Red to indicate the unit’s Battery Status. 80 - 100% 41 - 79% 1 - 40%...
- Page 9 HOW TO CHARGE THE UNIT AT HOME 1. Connect the AC adapter to the single pin connector port on the side of the unit and plug into a wall outlet. 2. The LED Indicator ring will flash blue while charging and light solid blue when fully charged.
- Page 10 HOW TO CHARGE THE UNIT IN YOUR CAR 1. Connect the DC charging cable to the unit’s dual pin connector and plug it into the vehicle’s accessory outlet. 2. Press the Main Power button to turn the unit ON.* 3. Depending on vehicle voltage the unit may start to flash blue indicating it is recharging.
-
Page 11: Fault Indicators
FAULT INDICATORS Multi-colored flashes indicate the unit is not able to perform. The Indicator ring will cycle between two colors: RED : : BLUE The unit is overheating or the clamps are installed in reverse. RED : : GREEN The unit has detected a problem with the vehicle’s battery. RED : : YELLOW The unit's internal battery is extremely low and needs to be... - Page 12 www.blackanddecker12volt.com/powertogo...