Table of Contents
Advertisement
The cable management kit includes two brackets and fasteners to secure the brackets to the inner
sides of the interface processor end of the chassis. By routing cables through the brackets and away
from the interface ports, you can keep cables sorted and organized, provide strain relief for heavy or
lengthy cables, and maintain clear access to interface processors and ports in the lower slots.
Before installing the rack-mounting hardware or the cable management brackets, read the safety
guidelines and prerequisites in the following section, "Prerequisites."
Prerequisites
The following sections provide safety guidelines that you should follow to avoid injuring yourself
or damaging the equipment, a list of the tools and parts you need, and guidelines for rack-mounted
equipment that will help you to avoid overtemperature conditions and maintain trouble-free
operation.
Safety Guidelines
Review the following guidelines to help ensure your safety and protect the equipment against
damage during the installation.
Working with Electrical Equipment
When working with any electrical equipment, the following guidelines will help to ensure your
safety and protect the equipment. This list is not inclusive of all potentially hazardous situations, so
be alert.
•
Never try to lift an object that is too heavy for you to lift safely by yourself.
•
Keep tools and chassis components away from walk areas.
•
Do not work alone when potentially hazardous conditions exist.
•
Do not wear loose clothing, jewelry (including rings and chains), or other items that could get
caught in the chassis. Fasten your tie or scarf and sleeves.
•
Never install equipment that appears damaged.
•
Disconnect all power and external cables before moving the chassis.
•
Never assume that power has been disconnected from a circuit; always check.
•
Do not perform any action that creates a potential hazard to people or makes the equipment
unsafe.
•
Carefully examine your work area for possible hazards such as moist floors, ungrounded power
extension cables, and missing safety grounds.
In addition, use the guidelines that follow when working with any equipment that is connected to
telephone wiring or other network cabling.
•
Never install telephone wiring during a lightning storm.
•
Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
•
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
•
Use caution when installing or modifying telephone lines.
Cisco 7010 and Cisco 7505 Rack-Mount and Cable Management Kits Installation Instructions
Prerequisites
3
Advertisement
Table of Contents
