Basic Operation - Sharp AH-XP10 B Series Operation Manual

BASIC OPERATION

OPERATION CONDITION
Mode
Upper limit
Cooling
Lower limit
• The build-in safety device may prevent
the unit from operating when used out of
this range.
• Condensation may form on the air outlet
if the unit operates continuously in the
COOL or DRY mode when humidity is
over 80%.
2
4
3
1
Indoor Outdoor
Temp. Temp.
32°C 43°C
21°C 21°C
1
Press the MODE button to select the op-
eration mode.
FAN AUTO COOL DRY
2
Press the ON/OFF button to start opera-
tion.
• The green OPERATION lamp (
TO TURN OFF
Press the ON/OFF button again.
• The green OPERATION lamp (
3
Press the THERMOSTAT button to set the
desired temperature, you can set temper-
ature in 0.5 C increments.
°
(AUTO/DRY mode)
The temperature can be
changed up to ±2.0°C from
the automatic setting.
(COOL mode)
The temperature setting
range: 14.0-30.0°C.
4
Press the FAN button to set the desired
fan speed.
AUTO BREEZE QUIET SOFT LOW
In FAN mode, fan speed cannot be set to AUTO.
B REEZE QUIET SOFT LOW
NOTE:
AUTO MODE
In the AUTO mode, the temperature setting and
mode are automatically selected according to the
room temperature when the unit is turned on.
DRY MODE
The fan speed is preset to AUTO and cannot be changed.
WHEN POWER FAILURE OCCURS
This air conditioner has a memory function to store
setting when a power failure occurs.
After power recovery, the unit will automatically re-
start in the same settings which were active before
the power failure, except for TIMER, POWERFUL
JET / SUPER JET, BEST SLEEP, BABY MODE, ECO
MODE, SELF CLEAN settings.
EN-6 EN-6
) will light up.
) will turn off.
HIGH
HIGH