Troubleshooting Fcip Connections; One-To-One Fcip Tunnel Creation And Monitoring - Cisco MDS 9000 Series Troubleshooting Manual

Chapter 5 Troubleshooting IP Storage Issues
S e n d c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Troubleshooting FCIP Connections

This section contains information on troubleshooting FCIP tunnels with and without Special Frames.

One-to-One FCIP Tunnel Creation and Monitoring

This section describes the configuration for one-to-one FCIP tunnel with FCIP debug activated (MDS2)
and without debug activated (MDS1).
Figure 5-2 One-to-One Topology
FC
FC1/14
First, perform the following steps to configure the MDS1.
Step 1 Enter configuration mode
Step 2 Set the interface
MDS1(config)#inteface gig 2/8
Set the IP address
Step 3
MDS1(config-if)#ip address 10.10.10.2 255.255.255.0
Enter no shutdown for some reason
Step 4
MDS1(config-if)#no shutdown
Enter the profile number and profile mode.
Step 5
MDS1(config)# fcip profile 28
The profile number can be any number between 1 – 255
Step 6 Enter the IP address of the local GE port that will be endpoint of FCIP tunnel.
MDS1(config-profile)# ip address 10.10.10.2
Step 7 Exit profile mode.
MDS1(config-profile)# exit
Step 8 Set the interface FCIP and enter interface mode.
MDS1(config)# interface fcip 28
OL-5183-02, Cisco MDS SAN-OS Release 1.3
MDS1 MDS1
GE 2/8
10.10.10.2/24
Fcip profile 28
IP adress 10.10.10.2
Interface fcip 28
(VE Virtual E-Port)
use-profile 28
peer-info ipaddr 10.10.11.2
Figure 5-2 shows the one-to-one topology used for configuration.
IP
GE 2/8
Network
10.10.11.2/24
Fcip profile 28
IP adress 10.10.11.2
FCIP Tunnel
Interface fcip 28
use-profile 28
peer-info ipaddr 10.10.10.2
Cisco MDS 9000 Family Troubleshooting Guide
Troubleshooting FCIP Connections
MDS2
FC
FC1/1
HBA
5-5