Advertisement
EN
Problem
Possible cause
Water is collected
You have put in dripping wet
at the bottom of
garments.
the appliance, or
leaks from the
appliance during
operation.
Garments are not
You have put in too many
dried.
garments or the set time is
too short.
You have put the wet garments
on the bottom tray.
Air outlet opening is covered.
Operation does not
You have not selected the
start after pressing
garment load.
the start button.
The door is not closed properly.
Touchscreen is
You are wearing gloves or
unresponsive or
using other object to touch the
insensitive.
screen.
There are substances (e.g. dirt)
on the screen which cause it to
be unresponsive.
You have pressed the mode,
load or start button during
operation.
You have pressed any of the
buttons when door is open or
not closed properly.
Solution
Turn off the appliance and wait for it to cool down.
Remove the garments, and wipe off the water
collected with a dry cloth.
Always remove extra water from the garments
before putting into the appliance.
Put fewer garments or select longer time. See the
section for recommendation.
As garments differ in type, size, fabric and initial
moisture content, you may need to try different time
settings. For drying function, if the garments are not
fully dried after the set time has elapsed, add extra
time.
Only use the top rack to hang the garments.
Do not cover the air outlet opening during
operation.
Press the load button to select the appropriate
garment load.
Close the door properly and press the start button
again.
Use only your finger to touch the screen.
Wipe the substances off the screen with a dry cloth.
These buttons are designed to be unresponsive during
operation . This is to prevent accidentally pressing of
the buttons and causing interruption to the operation.
These buttons are designed to be unresponsive
when door is open to ensure your safety. Close the
door properly.
23
Advertisement
