AEG L9FEC49S User Manual page 38

Table of Contents

Advertisement

38
www.aeg.com
Problem
There is water on the
floor.
You cannot open the ap-
pliance door.
The appliance makes an
unusual noise and vi-
brates.
The programme duration
increases or decreases
during programme exe-
cution.
The washing results are
not satisfactory.
Too much foam in the
drum during the washing
cycle.
Excessive liquid leakage
form the detergent dis-
penser.
Possible solution
• Make sure that the couplings of the water hoses are tight
and there is not water leakages.
• Make sure that the water inlet hose and the drain hose have
no damages.
• Make sure you use the correct detergent and the correct
quantity of it.
• Make sure that a washing programme that ends with water
in tub, has been selected.
• Make sure that the washing programme is finished.
• Set the drain or the spin programme if there is water in the
drum.
• Make sure that the appliance receives electrical power.
• This problem may be caused by a failure of the appliance.
Contact the Authorised Service Centre. If you need to open
the door, please read carefully «Emergency door opening».
• Make sure the levelling of the appliance is correct. Refer to
'Installation instruction'.
• Make sure that the packaging and/or the transit bolts are
removed. Refer to 'Installation instruction'.
• Add more laundry in the drum. The load may be too small.
• The ProSense function is able to adjust the programme du-
ration according to the type and the laundry load size. Re-
fer to 'The ProSense load detection' in 'Daily Use' chapter.
• Increase the detergent quantity or use a different deter-
gent.
• Use special products to remove the stubborn stains before
you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• Make sure that no other type of detergent has been poured
the compartment
tergent or other additives from salt compartment'.
• Make sure that no salt has been poured in the compart-
ment
. If it happens, run a rinse cycle or run the washing
cycle again.
• Reduce the quantity of detergent.
• Make sure that the rubber brushes under the detergent
compartment are intact.
Salt
. In this case, refer to 'Eliminating de-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents