▶ Pull the HDD/SSD module completely out of its bay.
Installing a 2.5-inch dummy module
CAUTION
▶
If the removed HDD/SSD module is not replaced immediately,
always replace a dummy module into the unused HDD/SSD bay to
comply with applicable EMC regulations and satisfy cooling
requirements.
Figure 76: Installing the 2.5-inch dummy module
▶ Push the dummy module into the empty bay until it engages.
Concluding steps
No steps needed.
7.5.4
Replacing a 2.5-inch HDD/SSD module
Customer Replaceable
Unit (CRU)
Tools:
– Installation frame included: tool-less
– Installation frame excluded: Phillips PH1 / (+) No. 1 screw driver
RX1330 M4
Hard disk drive (HDD) / solid state drive (SSD)
Upgrade and Maintenance Manual
Hardware: 5 minutes
157