Table of Contents
Advertisement
4 Set Up Network Connection
7
Press
or
to select the settings you
want to check, then press [OK].
V I E W
I P
A D D R E S S
1 . I P
A D D R E S S
−
<1. IP ADDRESS>
−
<2. SUBNET MASK>
−
<3. GATEWAY ADDRESS>
When the machine is communicating to the network
properly, the IP address, subnet mask and gateway
address are displayed. If not, IP address, subnet mask
and gateway address are not displayed.
–
Take a note of the IP address you confirmed here,
because you need it for using the Remote UI.
–
If the machine does not get the IP address after you
connect the LAN cable, perform the procedure below.
Turn OFF the main power switch → wait for at least 10
seconds → turn ON the main power switch → wait for 90
seconds.
If the machine still does not get the IP address, consult
your network administrator.
8
Press
[Stop/Reset] to return to the standby
mode.
The settings for the Static IP, see "Network Settings, " in the
e-Manual.
Check Network Connectivity
1
Start the web browser on the computer that is
connected to the network.
2
Enter the IP address in the address bar, then
press [Enter] on the keyboard.
The IP address to enter is the one that was confirmed in
"Check IP Address Setting, " on p. 9.
If the number within a segment begins with a zero (0),
you can omit the zero (0) at the beginning.
Example: 123.034.050.006 = 123.34.50.6
10
3
The Remote UI screen is displayed.
If the Remote UI screen does not appear, see "Settings
from a PC, " in the e-Manual.
Advertisement
Table of Contents
