Windows Does Not Start Up; When Logging On (E.g., Resuming The Computer), Audio Is Distorted; To Switch Between Windows 7 (64-Bit) And Windows 7 (32-Bit); Remove Disks Or Other Media. Press Any Key To Restart" Or A Similar Message Appears - Panasonic CF-S10 Series Operating Instructions Manual

Question
Windows does not
start up.
When logging on
(e.g., resuming the
computer), audio is
distorted.
To switch between
Windows 7 (64-bit)
and Windows 7
(32-bit).
"Remove disks or
other media. Press
any key to restart"
or a similar message
appears.
If the power indicator
the hard disk, and then slide the power switch for four seconds or longer to
turn off. Then turn on again.
When turning on the power the first time after purchase
The "The computer restarted unexpectedly or encountered an unexpected error."
message may be displayed instead of the Windows setup screen. This message
is displayed if the computer was forcibly turned off before the Windows setup
started (the AC adaptor was disconnected, or the battery ran out while you
perform the setup with the AC adaptor disconnected), and Windows cannot be
used until Windows is reinstalled. If this happens, reinstall Windows.
If Windows does not start up when resuming from hibernation
Use the Recovery Disc to start [System Recovery Options] and execute [Startup
Repair] (  page 80).
If Windows still does not start up, use the Recovery Disc to reinstall Windows.
Press in the Setup Utility to return the Setup Utility settings to the
default values.
(  page 51)
Remove all peripheral devices (e.g. USB memory).
Using the following procedure, start up in Safe Mode, and check the error
details.
1 Turn on the computer, and when the [Panasonic] boot screen disappears
(after entering the password*
2 Release your finger when [Windows Advanced Options Menu] is displayed.
3 Using
or , select [Safe Mode].
4 Press
.
Follow the on-screen instructions.
*1 Supervisor Password or User Password set with the Setup Utility.
Depending on the processing status on Windows, sound may be interrupted
at Windows startup. You can mute the sound at startup.
1 Right-click the desktop and click [Personalize].
2 Click [Sounds] and remove the check mark from [Play Windows Startup
sound], and click [OK].
The following methods are available to switch between Windows 7 (64-bit)
and Windows 7 (32-bit) (for example, to install Windows 7 (32-bit) on a hard
disk on which Windows 7 (64-bit) is installed).
•
Reinstall Windows by using the data in the HDD recovery partition on the hard
disk.
•
Reinstall Windows by using a Recovery Disc with the same OS as the OS you
want to install.
•
If you do not have a Recovery Disc with the same OS, reinstall Windows by
using a Recovery Disc with a different OS, and then reinstall Windows by using
the data in the HDD recovery partition.
A floppy disk is in the floppy disk drive and it does not contain system
startup information.
Remove the floppy disk and press any key.
Remove the USB device or set [Legacy USB Support] to [Disabled] in the
[Advanced] menu of the Setup Utility.
 page 54
If the problem persists, it may be a hard disk failure.
•
Perform the reinstallation and return the hard disk to its condition at the time of
purchase. (  page 81)
Measure
is lit, confirm that the computer does not access to
1
if one is set) hold down .
65