Using Advanced Controls; Manually Setting Spindle Speed - Grizzly G0931 Owner's Manual

Using Advanced
Controls
All the basic controls of the G0931 are performed
through single-button commands on the control-
ler, but some advanced features require multi-
button commands to access.
Advanced Processing Menu
Advanced tool functions are accessed through the
advanced processing menu. Functions include
array work, resuming stopped jobs, surfacing a
workpiece, calculating bounds of a file, and calcu-
lating processing time of a file.
To access advanced processing menu:
1.
Hold down RUN/PAUSE, then press HIGH/
LOW and release buttons together.
Switching Coordinate Systems
Up to nine work coordinate systems can be saved
at a time. When work origin is set, it is set for the
active coordinate system. If the absolute coordi-
nate system is active, work origin cannot be set.
To access advanced processing menu:
1.
Hold down MENU, then press one 0-9 num-
ber button and release buttons together.
— Press MENU + 0 to activate absolute coor-
dinate system (mechanical coordinates).
— Press MENU + 1-9 to activate work coor-
dinate systems.
-34-
Manually Setting
Spindle Speed
Pressing ON/OFF and Z+ or Z- buttons together
while the spindle is running will increase or
decrease the spindle speed through a range of
eight user-defined speed settings.
This action can be performed any time the spindle
is running.
To manually set spindle speeds:
1. Verify S-code processing is turned on (see
S-Code Processing on Page 33).
2. Press MENU, then scroll to "MACHINE
SETUP" and press OK.
3. Scroll to "Spindle Setup" and press OK.
4. Scroll to "Spindle State" and press OK.
5. Press STOP button twice to access "Spindle
Speed" menu.
6. Scroll through each spindle speed and set as
desired using RUN/PAUSE button and num-
bered keys.
Note: Set RPM values in ascending order
from 1–8. Speed 1 should be set to the low-
est RPM value, and Speed 8 should be set to
the highest RPM value.
7.
Press OK to save changes.
Model G0931 (Mfd. Since 02/21)