30" (76.2 cm) and 36" (91.4 cm) range hood (32 pages)
Summary of Contents for KitchenAid KVWB606HBS0
Page 1
Instructions d’installation et Guide d’utilisation et d’entretien Au Canada, pour assistance, installation ou service, composez le 1-800-807-6777 ou visitez notre site web à www.kitchenaid.ca IMPORTANT: READ AND SAVE THESE INSTRUCTIONS. FOR RESIDENTIAL USE ONLY. IMPORTANT : LIRE ET CONSERVER CES INSTRUCTIONS. POUR UTILISATION RÉSIDENTIELLE UNIQUEMENT.
RANGE HOOD SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.
Page 4
IMPORTANT SAFETY INSTRUCTIONS Ducted fans must always be vented to the outdoors. For General Ventilating Use Only. Do Not Use To Exhaust Hazardous Or Explosive Materials And Vapors. To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Fan With Any Solid-State Speed Control Device.
INSTALLATION REQUIREMENTS Tools and Parts Location Requirements Gather the required tools and parts before starting installation. IMPORTANT: Observe all governing codes and ordinances. Read and follow the instructions provided with any tools listed Have a qualified technician install the range hood. It is the here.
Cabinet Dimensions Venting Requirements 10" (25.4 cm) min. (Vented Models Only) 13" (33.0 cm) max. 2" (5.1 cm) min. Vent system must terminate to the outdoors except for ■ 9" (22.9 cm) min.* non-vented (recirculating) installations. Do not terminate the vent system in an attic or other ■...
For Non-Vented (Recirculating) Installations Electrical Requirements If it is not possible to vent cooking fumes and vapors to the outside, the hood can be used in the non-vented (recirculating) Observe all governing codes and ordinances. version using a Recirculation Kit (which includes charcoal filters Ensure that the electrical installation is adequate and in and a deflector).
INSTALLATION INSTRUCTIONS Prepare Location It is recommended that the vent system be installed before 5. For wood, drill 3/16" (4.8 mm) pilot holes at all locations ■ hood is installed. where screws are being installed into wood. For wall anchors, drill 7/16" (10 mm) holes at all locations Before making cutouts, make sure there is proper clearance ■...
For Vented Installations Only: Install In-Line Smart Kit (Optional) 1. Fit vent system over the exhaust outlet. NOTE: Your range hood can work with either an internal or an 2. Seal connection with clamps. in-line (external) blower motor system. An optional In-Line Smart 3.
Make Electrical Connection 4. Run home power supply cable through strain relief into WARNING terminal box. Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. 1.
Secure the bottom of the duct with two 4.2 x 8 mm screws. Install Vent Covers When using both upper and lower vent covers, push lower cover down onto hood and lift upper cover to ceiling and install with two 4.2 x 8 mm screws. NOTE: For vented installations the upper vent cover may be reversed to hide slots.
To Set Auto Sense: Manual Vent Functions Press AUTO. To Select Auto Sense Cooktop Type: Fan Speeds NOTE: The range hood is factory-set for the gas cooktop Press LOW to turn the fan on at Low speed. mode. Press MED to turn the fan on at Medium speed. 1.
Page 13
2. Remove each filter by pulling the spring release handle and Replacing a Halogen Lamp (Ambient Lighting) then pulling down the filter. Turn off the range hood and allow the halogen lamp to cool. To avoid damage or decreasing the life of the new lamp, do not touch lamp with bare fingers.
WIRING DIAGRAM N GND User Interface AUTO-SPEED SENSOR 25 uF OUTPUT: 700mA (2-15VDC) DRIVER INPUT: 120VAC MOTOR SPECIFICATIONS 120 VAC POWER SUPPLY FREQUENCY 60 HZ 420 W POWER ABSORTION MOTOR RESISTANCE ( ) BLUE-BLACK SE13XD BLUE-GREY 14.3 BLUE-RED BLUE-WHITE 21.6...
Recirculation Kit For Further Assistance (for non-vented installations only) If you need further assistance, you can write to KitchenAid with Order Part Number W10692908 any questions or concerns at: Chimney Extension Kit - Stainless Steel KitchenAid Brand Home Appliances...