Installation Guide - Black & Decker BDT20WTB Instruction Manual

SET UP & USE

INSTALLATION GUIDE

When you open the box, you should have received:
Portable dehumidifier
User Guide
Castors (4)
Continuous Drain Kit
If you purchased a model with a pump (BDT50PWTB) there will be an additional
pump drain kit
To Install Castors:
1. For the 20 pint model (BDT20WTB) and the 30 pint model (BDT30WTB)
gently lift the lid of the bucket (see fig 1).
For the 40 pint model (BDT40WTB) and the 50 pint models (BDT50WTB,
BDT50PWTB) gently lift off the lid of the bucket (see fig 2). Do not pull on handle.
2. Tilt the dehumidifier no more than
45 degrees and push to insert the castors
into the base of the unit. Make sure the ring
around the castor is flush against the
bottom of the dehumidifier. (see fig. 3).
Fig. 2
Fig. 3
Castors and
other accessories
1.Using two hands gently remove lid
from the top of the bucket.
lid
Bucket
Fig. 1
2.Remove casters
from bucket
Buckle
3.Re-install the lid and be
sure that it is securely
clipped into the bucket
Hole
Page 7
Important No
system on the
securely insta
before placin
dehumidifier