Package Contents DCS-850L Wi-Fi Baby Camera Wall Mount Kit Power Adapter Additional Accent Rings Mounting Bracket Quick Install Guide If any of the above items are missing, please contact your reseller. Minimum Requirements Mobile Requirements: • Refer to the mydlink Baby app page on the App Store and Google Play Computer Requirements: • Computer with 1.3GHz processor or above and at least 128 MB RAM • Microsoft Windows® 8, 7 , Vista®, or Mac OS® X (10.6 or higher) • Internet Explorer® 7, Firefox®12, Safari® 6, or Chrome™ 20 or higher with Java installed and enabled Network Requirements: • 802.11g/n Wi-Fi network (Wireless N network recommended for optimal performance) Remote Viewing: • Internet access required for remote viewing (Direct Connection requires no Internet connection and no router)
Hardware Overview Front View Night Vision Light (IR) Camera Lens Microphone Front Accent Ring Light Sensor Cloud/Direct Mode Power LED Base Accent Ring Back View Speaker Temperature Sensor Reset Button Direct Connect Micro-USB Power Port Button...
2. Remotely... Connect to your DCS-850L using the Internet. Note: You can also connect directly to your DCS-850L wirelessly, so there is no need for an Internet connection or a router. See the Advanced Features section of the User Manual for...
Installation WARNING - STRANGULATION HAZARD Children have STRANGLED in cords. Keep the adapter cord out of reach of children (minimum of 3 ft or 1 m away). NEVER place the camera or adapter cord inside the crib or child sleeping area. Do not use extension cords. This product is NOT intended to replace proper supervision of children.
Mount the Camera Please refer to the steps below to assist you with mounting the camera. We suggest that you configure the camera before mounting. Warning: Indoor use only. Do not mount the camera in a location where it may be in contact with water as it may damage the product and/or cause injury. • Place the mounting bracket where you want to position the camera and use a pencil to mark the points where you will drill the holes. • Use a 6mm drill bit to drill the two holes where you marked. The holes should be 25mm deep (about 1 in deep). Insert the screws into the holes. Note: If the wall is made out of concrete, before inserting the screws, insert the provided plastic anchors to support the screws.
Page 8
FAQs 1. How do I change the accent ring? Rotate the access ring counter clockwise, then lift it off. Put the new ring on and rotate it clockwise until it clicks into place. 2. How do I select a different lullaby? Use the mydlink Baby app to change the lullaby. Tap on the Music icon on the camera’s Live View screen. Choose a lullaby from the list, or you can select Play All. I started the mydlink Baby Camera Monitor app, but I can’t find my camera. • Make sure your camera is turned on and receiving power. • If you have set up your camera before, make sure your smartphone or tablet is connected to the same router as your camera.
Page 9
7. How can you power the camera? The camera can be powered with the provided power adapter or you can use an external USB battery for total portability. (USB battery is not included. Requires 5V/2A output.) 8. How do I access the camera remotely? Set up a new mydlink account and/or register the camera with mydlink during the initial setup. Once the process is complete, you can access the login screen for your mydlink account from the Home page by sliding the Home icon switch to the right. Enter the E-mail address and Password for your mydlink account and tap Log in.
Page 10
11. How do I activate push notifications? A. Go to the Home page and slide the Home icon switch to the right for remote access. B. After logging in, you will notice that the refresh icon on the top right has changed to an alarm clock icon. C. Tap on the Alarm Clock icon, and you will see the Push Notification setting. Tap on the Switch icon to activate push notifications. The switch icon will turn green, and you should begin to receive alerts as specified. Note: If you do not receive alerts, go to the Configuration menu and adjust the sensitivity level of sound and motion detection as described on the previous page, question 10.