Table of Contents
Advertisement
A
B
008439
ALWAYS hold the tool firmly with one hand on rear
handle and the other on the side handle. Turn the tool on
and then apply the wheel or disc to the workpiece. In
general, keep the edge of the wheel or disc at an angle of
about 15 degrees to the workpiece surface. During the
break-in period with a new wheel, do not work the grinder
in the B direction or it will cut into the workpiece. Once
the edge of the wheel has been rounded off by use, the
wheel may be worked in both A and B direction.
Installing or removing diamond wheel
(optional accessory)
CAUTION:
Make sure that the arrow on the tool should point in
•
the same direction as the arrow on the diamond
wheel.
008445
Screw the inner flange onto the spindle. Fit the diamond
wheel on over the inner flange and screw the lock nut
onto the spindle. Notice that flat side of the lock nut
should face the diamond wheel in case the diamond
wheel is used.
WARNING:
Only actuate the shaft lock when the spindle is not
moving.
Base (optional accessory)
When you wish to use a diamond wheel, install the base
on the tool. Loosen the screw on the wheel cover with a
screwdriver. Move the wheel cover to a convenient
position and secure it by tightening the screw.
15
1. Lock nut
1
2. Diamond wheel
3. Inner flange
2
3
008440
Install the base on the wheel cover using the hole in the
wheel cover.
008441
Secure the base in place by tightening the wing nut.
008442
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
001145
8
1. Screwdriver
1
1. Wing nut
1
2. Spring washer
3. Plain washer
2
3
4. Base
4
5. Bolt
6. Wheel guard
5
6
1. Limit mark
1
Advertisement
Table of Contents
