Table of Contents
Advertisement
Functions
Full-range Speaker (Rear)
Bottom
q Tiltable pole socket
This mount has two pole sockets. You can choose the
angle of the speaker so that it is positioned horizontal to
the floor or tilting down toward the floor by 7 degrees.
Compatible with commercially available speaker stands
and speaker poles of 35 mm diameter. (These sockets are
not available on the DZR315(-D).)
7°
Pole socket
FRONT
7°
0°
w Screw holes for U-bracket
For installing with the separately sold U-brackets. (These
sockets are not available on the DZR315(-D).)
e Screw holes for eye bolts
For installing the speaker using eye bolts. The screw holes
for eye bolts go through the cabinet wall.
w
e
q
Subwoofer (Rear)
r
y
r Dual pole sockets
Compatible with commercially available speaker poles of
35 mm diameter and M20 screw.
35 mm
diameter
When using a pole socket to install a speaker, observe the
following conditions for safety.
Subwoofer
Speaker to be installed
Weight: 26 kg or less
DXS18XLF(-D)
Height: 76.0 cm or less
(DZR15(-D) or smaller)
Weight: 22 kg or less
Height: 64.5 cm or less
(DZR12(-D) or smaller)
DXS15XLF(-D)
Weight: 18 kg or less
Height: 53.7 cm or less
(DZR10(-D) or smaller)
t Feet cups
When stacking multiple speakers, align the rubber feet of
the upper speaker to the feet cups of the lower one.
y Wheel mounting screws
For installing the separately sold Yamaha SPW-1 wheels. If
you are not using wheels, do not remove these screws.
Otherwise, the leakage of air will affect sound quality.
NOTE
• For more information about installing wheels and related pre-
cautions, refer to the corresponding manual for the wheels.
• Do not install any item other than the SPW-1 wheels.
Full range
Subwoofer
t
M20 screw
Length of the pole
104 cm or less
82 cm or less
104 cm or less
7
Advertisement
Table of Contents
