Page 1
Instruction Manual Outdoor Table Heater Model: SBT-15S Thank you for purchasing your new heater. These operating instructions will help you use it properly and safely. We recommend that you spend some time reading this instruction manual in order for you to fully understand all of the operational features it offers.
Safety warnings READ ALL INSTRUCTIONS BEFORE ATTEMPTING TO OPERATE THIS UNIT. KEEP THE ASSEMBLY INSTRUCTIONS FOR FUTURE REFERENCE. -Read all instructions before using this unit. -Do not leave this unit unattended when in use. -This heater will get hot when in use. Do not touch hot surfaces. -Caution: Some parts of this product can become very hot and cause burns.
heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. -Warning: This heater is not equipped with a device to control the room temperature. Do not use this heater in small rooms when occupied by persons not capable of leaving a room on their own, unless constant supervision is provided. -Always use on a dry, suitably strong, stable, flat and level surface.
Operating Instructions Use power switch to control heating element on/off Specifications Model: SBT-15S Voltage AC110-120V Frequency 50/60Hz Electric Power 1500W - This symbol on the product or in the instructions means that your electrical and electronic equipment should be disposed at the end of its life separately from your household waste.
Except as provided below, RADtec is not liable for any loss, cost, expense, inconvenience or damage that may result from use or inability to use the heater. Under no circumstances shall RADtec be liable for any loss, cost, expense, inconvenience or damage exceeding the purchase price of the heater.
RADtec accepts no liability for problems caused by after-market parts and hardware modifications or additions. RADtec is not responsible for giving any technical support concerning the installation or integration of any component the customer did not pay RADtec to install. This warranty is null and void if the defect or malfunction was due to damage resulting from operation not within manufacturer specifications.