JVC VS-DT2000 Service Manual page 9

Removing the tuner board
Remove the top lens.
Remove the bottom panel.
Remove the top panel.
Remove the CD mechanism assembly.
1. Disconnect the card wire from connector CN111 on
the main board.
2. From the rear side of the main body, remove the
two screws H attaching the FM/AM antenna
terminals on the tuner board.
3. Take out the tuner board from the bottom chassis.
Removing the speaker board
Remove the top lens.
Remove the bottom panel.
Remove the top panel.
Remove the CD mechanism assembly.
1. Remove the tie bands bundling the wires on the
speaker board.
2. Disconnect the wires from connectors CN101 and
CN102 on the speaker board.
3. From the rear side of the main body, remove the
three screws J attaching the speaker/digital out
terminals on the speaker board.
4. Take out the speaker board from the bottom
chassis.
[Reference]
After connecting the wires to the speaker
board, bundle them using a tie band.
Insert the CD mechanism assembly wire into
the notch on the bottom chassis. (See Fig. 8.)
(See Figs. 8 and 9.)
(See Figs. 8 and 9.)
Notch
Speaker board
CN102
Tie band
Tuner board
CN111
Bottom chassis
Fig.8
J
Rear panel
Speaker terminal
Fig.9
VS-DT2000
CD mechanism
assembly wire
Tie band
CN101
Main board
H
FM antenna
terminal
AM antenna
terminal
H
Digital out terminal
1-9