JVC VS-DT2000 Service Manual page 14

VS-DT2000
Removing the traverse mechanism
assembly
Remove the CD servo board.
1. Remove the two screws C attaching the CD servo
board bracket.
2. Remove the two screws D attaching the traverse
mechanism assembly.
3. Disengage the claw e attaching the traverse
mechanism assembly and then take out the
traverse mechanism assembly.
Removing the pickup unit
Remove the CD servo board.
Remove the traverse mechanism assembly.
1. From the top side of the traverse mechanism
assembly, remove the two screws E attaching the
shaft.
2. From the traverse mechanism assembly, disengage
the section f of the pickup unit and then remove the
pickup unit with the shaft.
3. Pull the shaft out of the pickup unit.
4. Remove the screw F attaching the rack plate from
the pickup unit.
5. Remove the screw G attaching the P.S. spring from
the pickup unit.
1-14
(See Fig. 4.)
(See Figs. 5 and 6.)
Traverse mechanism
C
assembly
D
Claw e
Fig.4
Pickup unit
E
Shaft
Traverse mechanism assembly
Fig.5
Shaft
Pickup unit
F
Rack plate
Fig.6
CD servo board
bracket
D
Section f
E
P.S. spring
G