Honeywell TH3110DAIRCOMF Installation Manual page 10

Installation Guide
Installer system test
Follow the procedure below to test the heating and cooling system.
System switch
1 Set S S Y Y S S T T E E M M switch to Heat.
2 Press to turn on and check systems (see table, below).
3 Press until systems turn off.
4 Set switch to Em Heat and repeat steps 2-3 above.
S S Y Y S S T T E E M M
5 Set S S Y Y S S T T E E M M switch to Cool and repeat steps 2-3 above.
5 Press and hold
System Test
10 Heating system
20 Emergency heat
30 Cooling system
70 Thermostat
information
(for reference only)
CAUTION: EQUIPMENT DAMAGE HAZARD
Compressor protection (minimum off time) is bypassed during testing. To prevent
equipment damage, avoid cycling the compressor quickly.
to terminate test at any time.
System Status
0 Compressor and fan turn off.
1 Compressor and fan turn on.
2 Auxiliary heat turns on.
0 Heat and fan turn off.
1 Heat and fan turn on.
2 Auxiliary heat turns on.
0 Compressor and fan turn off.
1 Compressor and fan turn on.
71 Software revision number (major revisions)
72 Software revision number (minor revisions)
73 Configuration identification code (major)
74 Configuration identification code (minor)
75 Production configuration date code (week)
76 Production configuration date code (year)
System test System status
number
10
8
0
Test