Operation; Driving Nails - Makita DBN600 Instruction Manual

Nose adapter
CAUTION:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before installing the nose adapter.
When firing nails on the material with easily-marred
surfaces, use the nose adapter. Put the nose adapter
on the front end of the contact element.
Make sure that the nose adapter completely covers the
front end of the contact element as illustrated.
2
1
► 1 . Nose adapter 2. Contact element
You can store the nose adapter on the holder on the
magazine to keep it from being lost.
2
1
► 1 . Nose adapter 2. Holder
Hook
CAUTION:
Do not hang the hook from the
waist belt. Dropping the nailer, which is caused by
the hook accidentally coming out of place, may cause
unintentional firing and result in personal injuries.
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
3
► 1 . Groove 2. Hook 3. Screw

OPERATION

Inspecting trigger function
CAUTION:
Make sure that the trigger function
is in working order before each operation. The
tool must not operate only by pulling the trigger
or only by placing the contact element against the
workpiece. If you find such issues, contact Makita
authorized service centers for repairs.
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.

Driving nails

WARNING:
Continue to place the contact
element firmly on the material until the nail is
driven completely. Unintentional firing may cause
personal injuries.
9 ENGLISH
1
2