Operation - Makita CP100DSM Instruction Manual

► 1 . Switch trigger 2. Lock-off button
To start the tool, press the lock-off button and pull the
switch trigger. Release the switch trigger to stop. The lock-
off button can be pressed from either the right or left side.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
The blade can be warm during
operation. Before removing the blade, wait until
the blade cools down.
CAUTION:
Be sure to secure the blade firmly
to avoid injury or damage to the tool.
CAUTION:
When replacing the blade, always wear
gloves so that your hands do not directly contact the blade.
Replacing blade
1. Insert the lock pin included in the package of the
blade set into the free hole in the blade, and then loosen
the screw with a screwdriver.
2
► 1 . Screw 2. Lock pin
2. Remove the lock pin, and then remove the screw
and the blade.
3. Attach the new blade with its flat surface facing the
tool, then insert the lock pin, and then tighten the screw
firmly to secure the blade.
1
2
1
► 1 . Blade 2. Screw 3. Lock pin
4. Remove the lock pin.

OPERATION

CAUTION:
When operating the tool, do not
touch the blade or bring the tool near the hand
or face.
CAUTION:
When cutting the material, never
put the hand in front of the blade.
NOTICE:
Before operating the tool, make sure
that the blades are in the right position as shown
in the figure.
6 ENGLISH
3
1
2