Installing Hook - Makita XDT12Z Instruction Manual

Impact force grade displayed
on panel
A mode
NOTE: T mode and A mode is available only when the tool rotates clockwise. When rotating counterclockwise in T
mode and A mode, the impact force and speed are the same as max mode.
NOTE: When all lamps on the switch panel go out, the tool is turned off to save the battery power. The impact force
grade can be checked by pulling the switch trigger to the extent that the tool does not operate.
NOTE: While pulling the switch trigger, the impact force grade cannot be changed.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
12 mm
(15/32")
Use only the driver bit/socket bit shown in the figure. Do
not use any other driver bit/socket bit.
1
► 1. Driver bit 2. Sleeve
To install the driver bit, insert it into the sleeve as far as
it will go.
Maximum blows
-1
3,800 min (/min)
9 mm
(3/8")
2
Purpose
Tightening screws with better
control.
1
► 1. Driver bit 2. Sleeve
To remove the driver bit, pull the sleeve in the direction
of the arrow and pull the driver bit out.
NOTE: If the driver bit is not inserted deep enough
into the sleeve, the sleeve will not return to its original
position and the driver bit will not be secured. In this
case, try re-inserting the bit according to the instruc-
tions above.
NOTE: When it is difficult to insert the driver bit, pull
the sleeve and insert it into the sleeve as far as it will
go.
NOTE: After inserting the driver bit, make sure that it
is firmly secured. If it comes out, do not use it.

Installing hook

3
2
► 1. Groove 2. Hook 3. Screw
9 ENGLISH
Example of application
Tightening long screws.
2
1