Adjusting Saw Chain Tension - Makita XCU01Z Instruction Manual

In order to prevent kickback, do not remove the
•
bar tip or replace the guide bar with one without a
bar tip.
1
008566
Loosen the screw by turning counterclockwise the knob
until the sprocket cover comes off.
Remove the sprocket cover.
Remove saw chain and guide bar from the tool.
1
2
008568
Fit in one end of the saw chain on the top of guide bar.
At this time, fit the saw chain as shown in the figure
because it rotates in the direction of arrow.
2
013690
Place the saw chain so that the spring is positioned
inside it and fit in the other end of saw chain around the
sprocket as shown in the figure.
1. Sprocket cover
2
2. Knob
1. Cutter
2. Guide bar
3. Arrow
3
1. Spring
2. Sprocket
1
1
013691
While turning the guide bar counterclockwise, install it
so that the end of guide bar contacts the spring.
2
3
008569
Insert the hook of sprocket cover into the hole in the tool
and then place the sprocket cover on the tool.
008570
Turn the knob clockwise to tighten the screw firmly.

Adjusting saw chain tension

1
008587
8
1. Spring
2. Guide bar
2
1. Sprocket cover
1
2. Hook
3. Hole
2