English
16
Cleaning table
Part description
Brew group
Classic milk frother
Drip tray
Coffee grounds
container
Water tank
Pre-ground coffee
compartment/coffee
exit duct
Cleaning the brew group
When to clean
Weekly
Depending on the
type of usage
Monthly
After every use
Weekly
As soon as the red
'drip tray full' indicator
pops up through the
drip tray.
When it suits you
When it suits you
Weekly
Note: Scan the QR code or go to
instructions on how to disassemble and clean the brew group.
Caution: Do not clean the brew group in the dishwasher and do not use
washing-up liquid or a cleaning agent to clean it. This may cause the brew
group to malfunction and may have a negative effect on the coffee taste.
Cleaning the brew group under the tap
1 Switch off the machine and unplug it.
How to clean
Remove the brew group and clean it under the tap
(see 'Cleaning the brew group under the tap').
Lubricate the brew group (see 'Lubrication').
Clean the brew group with the coffee oil remover
tablets.
Rinse with fresh water (see 'Daily cleaning of classic
milk frother').
Disassemble the classic milk frother and clean all
parts under the tap (see 'Weekly cleaning of classic
milk frother and steam wand ').
Empty the drip tray and clean it under the tap.
Empty the coffee grounds container and clean it
under the tap. Make sure the machine is switched on
while you empty and clean the coffee grounds
container.
Clean it under the tap.
Clean the top part with a spoon handle as shown
below.
www.saeco.com/care
for detailed