Placement - Tripp Lite SmartRack 2400 Series Owner's Manual

Enclosure Installation
Unpacking
(continued)
4 Use the key to open the enclosure's doors and locate the 2 shipping brackets
enclosure to the shipping pallet. The brackets are located inside the enclosure. Note: The keys are
attached to the front of the enclosure.
5 Use a 13 mm open-end wrench to remove the shipping brackets. Be extremely careful, as the
enclosure could shift unexpectedly after bracket removal. Save the brackets and bracket hardware for
later use.
6 Position at least one person at the front of the enclosure and one person at the rear of the
enclosure. Slowly push the enclosure toward the back of the shipping pallet until all four casters go
over the edge of the pallet and touch the floor. WARNING: Use at least one assistant when
removing the enclosure from the pallet. Be extremely careful when moving the enclosure.

Placement

1 Use the casters to move the enclosure for a short distance over a level, smooth, stable surface by
pushing it from the front or rear (not the side panels). Do not attempt to roll the enclosure over long
distances. The enclosure should be moved close to its installation location inside its shipping
container before it is unpacked. (Use a forklift or pallet jack to move the shipping container.)
WARNING: Do not push or pull the enclosure at the side panels or pull the enclosure toward
you.
If required, the enclosure can be lifted by attaching 4 user-supplied M8 diameter eye bolts to the
threaded holes near the upper corners of the enclosure frame. Use steel bolts with an ISO strength rating
of 8.8 or higher. The 4 bolts can support the weight of the enclosure and up to 1000 lb (450 kg) of
installed equipment. WARNING: Only experienced equipment operators should attempt to lift the
enclosure. Use appropriate equipment and follow all applicable safety procedures and
regulations.
A that attach the
4
5
6
1
5
A