Change general settings
1
Press
SETUP .
2
Select [General Setup] , then press OK .
3
Select and adjust the following settings:
•
[EasyLink Setup] : Sets up EasyLink to
enjoy easy controls of all the HDMI
CEC compliant devices using a single
remote control (see 'Use Philips
EasyLink' on page 12 ) .
•
[Disc Lock] : Restricts play to disc.
Password (PIN code) is required to
unlock the disc before play.
•
[Display Dim] : Changes the brightness
of the display panel.
•
[OSD Language] : Selects the on-
screen display menu language.
•
[Screen Saver] : Enables or disables
screen saver mode. If enabled, the
screen enters idle mode after 10
minutes of inactivity (for example, in
pause or stop mode).
•
[Sleep Timer] : Sets a sleep timer to
switch the home theater to standby
after a speciÀ c time.
•
[DivX® VOD Code] : Displays the
DivX VOD registration code for the
home theater.
4
Press OK to conÀ rm your choice.
Note
•
Before you purchase DivX videos and play
them on the home theater, register the home
theater on www.divx.com using the DivX
VOD code.
14
EN
Change audio settings
1
Press
SETUP .
2
Select [Audio Setup] , then press OK .
3
Select and adjust the following settings:
•
[Speakers Volume] : Sets the volume
of each speaker to obtain the ideal
audio balance.
•
[Speakers Delay] : Sets the delay time
for center and rear speakers to obtain
an equal audio transmission from all
the speakers.
•
[HDMI Audio] : Enables or disables
HDMI audio output for the TV.
•
[CD Upsampling] : Converts the music
CD to a higher sampling rate using
sophisticated digital signal processing
for better sound quality.
•
[Audio Sync] : Sets a delay for audio
output when you play a video disc.
4
Press OK to conÀ rm your choice.
Note
•
For settings related to HDMI, the TV must be
connected through HDMI.
•
CD upsampling is only available in stereo
mode.