Table of Contents
Advertisement
Play in group mode
Group mode: If you have more than one
izzylink-compatible multiroom speakers, you can
create a group and stream music to the group
of speakers at the same time.
To use this feature, you need to purchase
more than one izzylink-compatible multiroom
speakers.
Note
•
You can create a group of up to five speakers, with one
as the master and four as slaves.
Create a group
Note
•
Whenever you create a group, the first speaker that
you enable the group function will act as the master.
1
Hold GROUP on the first speaker for
3 seconds (The master).
2
Hold GROUP on a second speaker for
3 seconds (The slave).
3
Wait for 15 to 30 seconds for connection
setup.
4
Repeat steps 1 to 3 to add more slave
speakers one by one.
Note
•
You can only add slave speakers one by one. Each time
when you add a slave speaker, first press and hold
GROUP on the master speaker until the indicator on
the button flashes and the speaker beeps.
•
If the signal strength indicator on a slave speaker shows
that the signal is poor, move it closer to the master
speaker.
You can add any of the following speakers into the
existing group or create a new group with them:
•
A speaker with factory default settings
•
A master speaker that has no slave
connected to it
•
A slave speaker that is disconnected from
its master (with the GROUP indicator
flashing)
Play from the master to the whole group
Note
•
In Bluetooth mode, music playback pauses when there
is an incoming call or video recording is in progress on
the connected mobile phone.
•
If this speaker (BM50) acts as the master,
select a source and play to the whole group of
speakers.
EN
13
Advertisement
Table of Contents
