Turn On; Set Clock; Demonstrate The Unit's Features; Store Radio Stations Automatically - Philips DCM2025 User Manual

Turn on

1
Press .
» The unit switches to the last selected
source.
Switch to standby mode
1
Press for over 3 seconds to switch the
unit to Eco Power Standby mode.
» The backlight on the display panel
turns off.
To switch the unit to standby mode:
1
In Eco Power Standby mode, press
over 3 seconds.
» The clock (if set) appears on the
display panel.

Set clock

1
In standby mode, press and hold
PROG/CLOCK SET for more than two
seconds to activate clock setting mode.
» [CLOCK SET] (clock set) scrolls on
the display, and then the time format
[24H] and [12H] is displayed.
2
Press / to select 24H or 12H, and
then press PROG/CLOCK SET.
» The hour digits begin to blink.
3
Press / to set hour, and then press
PROG/CLOCK SET again.
» The minute digits begin to blink.
4
Press / to set minute.
5
Press PROG/CLOCK SET to confirm the
clock setting.
EN
12
Note
•
To exit clock setting mode without storing, press
•
If no button is pressed in 90 seconds, the system exits
clock setting mode automatically.
Demonstrate the unit's
features
1
In the standby mode, press
ON" is displayed.
» This system's features are displayed
one by one.
for
• To turn off the demonstration, press
Store radio stations
automatically
If no radio stations are stored, the unit can store
radio stations automatically.
1
Turn on the unit.
2
Press FM.
» [AUTO INSTALL -- PRESS PLAY --
STOP CANCEL] (press
automatic installation, or press
cancel) is displayed.
3
Press
» The radio stations with sufficient signal
strength are stored automatically.
» After all available radio stations are
stored, the first stored radio station
broadcasts automatically.
again.
.
.
until "DEMO
to start
to